This Wheel Spacer Kit Comes with Everything Needed for a Full Installation!

Specifications

• Vehicle Bolt Pattern: 8x170
• Wheel Bolt Pattern: 8x170
• Hub Bore: 124.9mm
• Thread Pitch: 14x1.5
• Thickness: Each Spacer Measures 2" inch Thick
• WILL NOT WORK WITH TRUCKS WITH 14x2 (coarse thread) THREAD PITCH
• WILL NOT FIT OVER HUB OF TRUCKS WITH A FULL FLOATING REAR AXLE

Note: These spacers will only bolt onto the front of your vehicle.

Vehicle Fitments

THESE SPACERS WILL BOLT ONTO THE FRONT OF THE FOLLOWING VEHICLES:

• 1999-2015 Ford F250 Superduty (CHECK STUDS CAN BE EITHER A 14x2 OR A 14x1.5)
• 1999-2015 Ford F350 Superduty (CHECK STUDS CAN BE EITHER A 14X1.5 OR A 14x1.5)

Additional Information

• Please ensure that the your vehicle has the same studs as the adapters, otherwise additional lugs WILL BE required
• Make sure that all adapters get a FULL 6-8 Turns of the Lugs when Tightening, Failure to do so, can result in damage to your vehicle
• Installation needs to be performed by a trained professional

1. Your lugs studs will need to be shortened by grinding them down
2. You can replace your studs will shorter studs
3. if you wheels have cavities in the backside, between the mounting holes, then you should be OK (will need to make sure flush)
4. ALWAYS ENSURE THAT THERE IS NO GAP BETWEEN THE SPACERS AND THE HUB OF THE WHEELS