This Wheel Adapter Kit Comes with Everything Needed for a Full Installation!

Specifications

Vehicle Bolt Pattern: 5x100

Wheel Bolt Pattern: 5x112

Hub Bore: 57.1mm

Thread Pitch: 12x1.5

Thickness: Each Adapter Measures 1.25" inch Thick

Vehicle Fitments

THESE SPACERS WILL BOLT UP TO THE FOLLOWING VEHICLES (ADAPTERS ARE GOING TO CHANGE YOUR BOLT PATTERN

2000-2006 Audi TT (additional lug bolt/studs will be required for installation)

1989-2010 VW Beetle (additional lug bolt/studs will be required for installation)

1992-2006 VW Golf (additional lug bolt/studs will be required for installation)

1992-2005 VW Jetta (additional lug bolt/studs will be required for installation)

1990-1997 VW Passat (additional lug bolt/studs will be required for installation)

Please ensure that the your vehicle has the same studs as the adapters, otherwise additional lugs WILL BE required
Make sure that all adapters get a FULL 6-8 Turns of the Lugs when Tightening, Failure to do so, can result in damage to your vehicle
Installation needs to be performed by a trained professional

It's Possible that you OEM Studs are longer than the spacer is thick, if so you have a few options:

Your lugs studs will need to be shortened by grinding them down
You can replace your studs will shorter studs
if you wheels have cavities in the backside, between the mounting holes, then you should be OK (will need to make sure flush)
ALWAYS ENSURE THAT THERE IS NO GAP BETWEEN THE SPACERS AND THE HUB OF THE WHEELS